In this video you’ll learn how to make a slingbow
A sling-bow is basically a slingshot that’s altered to shoot arrows. They are pretty powerful depending on what materials you use to construct them with, and can be made on a very slim budget. So without further ado lets begin!
- A sling shot
- A golf tee
- An O-ring
- Two medium zip ties
- An old beat up arrow
- A few strips of duck tape
The first thing you need to do is to prep the sling shot. The first step in doing this is to take off the existing elastic bands, and discard them. Next take your heavy duty replacement bands and trim them until there’s 1 inch of band for every 5 inches of arrow.
For example I trimmed my bands to 5 1/2 inches, and they work perfectly with my 25” arrows. Next put your bands on and leaving a quarter inch to a half inch of extra band extending at the end. To test pull it back to it’s max draw and have someone measure the distance from the pocket to the extra bit of band on the sling shot.
You want this number to be less than the length of the arrow by one or two inches.
The arrow rest is what is going to hold the arrow before and during the release. You want the O-ring, to be perfectly vertical, so to do that you first need to put one of the zip ties through the O-ring and then around the end tag of the elastic band like in the picture above.
Don’t tighten it all the way yet, we’ll get to that later. Then next to get the ring to stand vertical you need to counter twist the other zip tie. If you are confused at this point just reference the pictures above.
Now tighten the zip ties until the ring is right in the center, and vertical.
If you need further instructions check out the original article here, http://www.instructables.com/id/Homemade-Sling-Bow/step8/The-Nock/